CP2E – read user manual online or download in PDF format. Pages in total: from the Crestron website (). 2. CP2E only. 2- Series Engine. At the heart of the CP2 & CP2E is the powerful bit Freescale. Crestron CP2E Pdf User Manuals. View online or download Crestron CP2E Operation Manual.
|Published (Last):||2 June 2018|
|PDF File Size:||17.24 Mb|
|ePub File Size:||10.51 Mb|
|Price:||Free* [*Free Regsitration Required]|
All Crestron certified Cresnet wiring must consist of two twisted pairs. Increase the separation between the equipment and receiver.
Crestron electronic CP2E User Manual – Page 1 of 40 |
Confirm properly defined signal definition in the program. Control system is not receiving power. Verify that proper IR or serial port is defined.
Apply the feet near the corner edges on the underside of the unit.
Press front panel SW-R and HW-R buttons cl2e the same time to bypass program and communicate directly with the processor. Repaired or replaced equipment and parts supplied under this warranty shall be covered only by the unexpired portion of the warranty. Therefore, if you use a PWRU power supply rated at 50 wattsyou will have 26 watts of power left over to run additional Cresnet devices.
You can also log onto the online help section of the Crestron website to ask questions about Crestron products. Got it, continue to print. Add Hubs Reference Documents The latest version of all documents mentioned within the guide can be obtained from the Crestron website http: The bussing strips are constructed with four terminal block positions and may be trimmed to size for various applications or different devices.
The foregoing remedy shall be your exclusive remedy for any claim or loss arising from the Software. Required for initial setup of Ethernet parameters.
Without prejudice maual any other rights, Crestron may terminate this Agreement immediately upon notice if you fail to comply with the terms and conditions of this Agreement. Bussing Strip Installation The 2-Series integrated dual bus control system is supplied with two brass bussing strips to facilitate commoning linking of multiple terminal block connections.
Ethernet CP2E only Crestron pioneered the IP-based control system to harness the ctestron possibilities of Ethernet and the Internet for remote control, monitoring, programming and diagnostics. The port is modem compatible modem and PC cables not included.
This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These updates are solely electronic and serve as intermediary supplements prior to the release of a complete technical documentation revision.
Tighten the terminal block screws to lock the wire and bussing strip into place. Check the Crestron website periodically for manual update availability and its relevance.
As such Crestron cannot and does not guarantee any results of use of the Software or that the Software will operate error free and You acknowledge that any development that You perform using the Software or Host Application is done entirely at Your own risk. Complete nanual following procedure to attach the ears to the unit.
For information on setting an IP table, refer to the Crestron Toolbox help file.
Crestron CP2 Operation Manual
This Agreement may only be modified by a writing signed by an authorized officer of Crestron. CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any application other than that for which it was intended, or if it has been subjected to misuse, accidental damage, modification, or improper installation procedures.
Ear Attachment for Cresstron Mounting 2. In the event that the clock fails, only an authorized crestrkn should replace it. To avoid damage to the CP2 or CP2E unit, be sure the mating Cresnet cable connector is properly aligned before attempting to insert it.
CRESTRON CP2 OPERATION MANUAL Pdf Download.
This warranty shall be the sole and exclusive remedy to the original purchaser. Any implied warranties that may be imposed by law are limited to the terms of this limited warranty. Don’t show me this message again. CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any application other than that for which it was intended, or if it has been subjected to misuse, accidental damage, modification, or improper installation procedures.
This device complies with part 15 of the FCC rules. Such flexibility can offer a cost-effective solution for system expansion, providing a host of additional control ports in a single module.